Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 851)

Brocade Network Advisor SAN + IP User Manual 795
53-1002949-01
Layer 3 access control list policy
22
3. Enter a name for the network in the Name field.
4. Enter a valid IP address (IPv4 format) in the Subnet field.
5. Enter a valid IP address in the Mask field.
If you use the ACL Network as the source IP address, the Subnet mask from the ACL Network
will be converted to Wildcard mask when deploying the ACL to the device.
The Network dialog box only accepts subnet mask.
6. Click OK on the Add Network dialog box.
7. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.
Editing a network
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 773
• “Editing a standard L3 ACL configuration” on page 775
• “Copying a standard L3 ACL configuration” on page 776
• “Creating an extended L3 ACL configuration” on page 777
• “Editing an extended L3 ACL configuration” on page 779
To edit a network, complete the following steps.
1. Click the Networks tab.
2. Select the network you want to edit in the List of Networks table and click Edit.
The Edit Network dialog box displays.
3. Enter a valid IP address (IPv4 format) in the Subnet field.
4. Enter a valid IP address in the Mask field.
5. Click OK on the Edit Network dialog box.
6. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.