Duplicating a discovery profile – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 170
Brocade Network Advisor SAN + IP User Manual
103
53-1002949-01
IP discovery profiles
4
9. Click Apply to save your changes.
10. Click Close to close the Discover Setup - IP dialog box.
11. Click Yes on the confirmation message.
Duplicating a discovery profile
NOTE
You cannot duplicate a discovery profile if you do not have the All IP Products AOR (area of
responsibility) in your user account.
NOTE
DCB devices discovered through Fabric discovery (from the SAN tab) are automatically added to IP
discovery during rediscovery.
To duplicate a discovery profile, complete the following steps.
1. Select Discover > IP Products.
The Discover Setup - IP dialog box displays.
2. Click the Profiles tab
3. Select the profile you want to copy and click Duplicate.
A new row (named “Copy of profile_name”) displays in the Discovery Profiles table
4. Click “Copy of profile_name” in the Profile Name field to enter a unique name for the profile.
This name can be from 1 through 255 characters long, case sensitive, and allows all printable
ASCII characters.
5. Click the Address Ranges tab to configure address ranges for the profile.
For step-by-step instructions, refer to
6. Click the Scheduling tab to configure a discovery schedule for the profile.
For step-by-step instructions, refer to
7. Click the Preferences tab to configure preferences for the profile.
For step-by-step instructions, refer to
“Configuring advanced discovery profile preferences”
8. Click the Global Settings tab.
To set SNMP credentials, refer to
To configure default user names and passwords, refer to
To configure global setting preferences, refer to
“Defining global setting preferences”
9. Click Apply to save your changes.
10. Click Close to close the Discover Setup - IP dialog box.
11. Click Yes on the confirmation message.