Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1597)

1550 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
IP sFlow configuration
43
12. Select the Layer 3 & 4 tab.
FIGURE 680 Add Report Definitions dialog box, Layer 3 & 4 tab
13. Examine each listed item and decide the following:
- Do you want to enter values in the field, or be prompted to enter the value when running
the report? If you want to be prompted, select the Prompt check box.
- If you choose to list values in the field, would you rather include or exclude the listed
values? The selector next to the field may be used to include (=) or exclude (!=) the values.
- Are the values relevant to the design of your report? If not, leave the fields blank.
14. If you do not chose the Prompt check box, you may enter any of the following in comma
separated value (CSV) format in the fields provided:
- Layer 3 Protocols — Enter the L3 protocols in comma separated value (CSV) format or click
the ellipsis button to the right of the field to select the protocols from the Layer 3 Protocols
dialog box.
- Source Addresses — Enter the addresses in comma separated value (CSV) format or click
the ellipsis button to the right of the field to select the addresses from the L3 Source
Addresses dialog box.
- Source Address Groups — Enter the addresses in comma separated value (CSV) format or
click the ellipsis button to the right of the field to select the addresses from the L3 Source
Address Groups dialog box.
- Destination Addresses — Enter the addresses in comma separated value (CSV) format or
click the ellipsis button to the right of the field to select the addresses from the L3 Source
Addresses dialog box.
- Destination Address Groups — Enter the addresses in comma separated value (CSV)
format or click the ellipsis button to the right of the field to select the addresses from the
L3 Source Address Groups dialog box.
- TOS/DSCP values — Enter one or more TOS or DSCP value (0-255).