Viewing san device properties – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 2002
1962
Brocade Network Advisor SAN + IP User Manual
53-1002949-01
SAN device properties
E
2. Click OK on the Fabric_Name Properties dialog box to close.
Viewing SAN device properties
To view the properties for a device, complete the following steps.
1. Right-click any product icon and select Properties.
The Properties dialog box displays, with information related to the selected device (such as,
switches, directors, HBAs, trunks, tunnels, and nodes).
To add user-defined property labels, refer to
Fields containing a green triangle ( ) in the lower right corner are editable.
Depending on the device type, some of the properties listed in the following table may not be
available for all products.
Last Discovery
The date and time of last discovery.
Tracked
Whether the fabric is tracked.
Location
The customer site location.
Contact
The primary contact at the customer site.
Add button
Click to add a user-defined property. For more information, refer to
Edit button
Click to edit a user-defined property. For more information, refer to
Delete button
Click to delete a user-defined property. For more information, refer to
TABLE 216
Device properties
Field/Component
Description
Addressing Mode
The addressing mode of the switch.
Back to Edge Routing Supported
Whether back to edge routing is supported.
Bandwidth
The bandwidth of the FCIP tunnel.
Capability
The node capability.
Compression
Whether compression is On or Off for the FCIP tunnel.
Connected Virtual FCoE Port
The fabric name, switch name, and virtual FCoE port number of the
connected virtual FCoE port.
Contact
The primary contact at the customer site.
Contributors
The device contributors.
Device Type
Whether the device is an initiator or target.
Description
A description of the customer site.
Destination IP Address
The IP address of the of the FCIP tunnel destination device.
TABLE 215
Fabric properties
Field/Component
Description