Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1417)

1368 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
VPLS Manager
37
c. You can select the IP address of the peer by clicking the drop down arrow for Peer IP
address. By default, the ingress IP address of a tunnel is selected.
d. Enter the maximum number of MAC entries that the VPLS instance is allowed to learn.
Determine the range of values you can enter by checking the configuration guide for your
device.
3. Click Next.
The Port Configuration page displays ( Figure 602 ).
FIGURE 602 VPLS Configuration wizard Port Configuration dialog box
Discovered VPLS port settings appear under Discovered Endpoint Settings.
Configuring endpoint settings
1. From the Port Configuration page of the VPLS Configuration wizard, select a port from the
Interfaces tree and click the Add button under Configured Endpoint Settings.
A row is added to the Configured Endpoint Settings list.
2. Click the empty Tag Mode field and select one of the following:
- Tagged if you want packets transmitted with a specified VLAN ID.
- Untagged if you want any VLAN ID removed before transmitting the packet.
3. If you chose Tagged mode, complete the following steps.
a. Click the empty Outer VLAN ID field and enter the VLAN ID you want to use.
b. Click the empty Inner VLAN ID field and enter the VLAN ID you want to use. Skip this step if
you are using single tagging.
4. Click Next.
The Deploy Target Actions dialog box displays ( Figure 603 ).