Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 190)

Brocade Network Advisor SAN + IP User Manual 123
53-1002949-01
Individual IP device discovery
4
FIGURE 41 SNMPv3 credentials
b. Enter the SNMPv3 user name in the User ID field.
The user name can be from 1 through 16 characters long, case sensitive, and allows all
printable ASCII characters.
c. Select one of the following protocols from the Authentication Protocol list:
• None
• HMAC_MD5
• HMAC_SHA
d. Enter the SNMPv3 authentication password in the Authentication Password field.
The password can be from 8 through 16 characters long, case sensitive, and allows all
printable ASCII characters. The password display as asterisks.
e. Select one of the following protocols from the Privacy Protocol list:
• None
• CBC-DES
• CFB_AES-128
If you select a privacy protocol, the selected protocol encrypts the SNMP request and
response packets.
f. Enter the privacy password in the Privacy Password field.
The password can be from 1 through 16 characters long, case sensitive, and allows all
printable ASCII characters. The password display as asterisks.
6. Configure the SNMPv3 read only credentials by completing the following steps.
a. Click the SNMPv3 Read Only tab.
b. Enter the SNMPv3 user name in the User ID field.
The user name can be from 1 through 16 characters long, case sensitive, and allows all
printable ASCII characters.
c. Select one of the following protocols from the Authentication Protocol list:
• None
• HMAC_MD5
• HMAC_SHA