Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1848)

Brocade Network Advisor SAN + IP User Manual 1807
53-1002949-01
MAPS actions
50
6. Click OK on the MAPS E-Mail Setup dialog box.
7. Click Close on the MAPS Configuration dialog box.
Viewing MAPS policy data
You can view the MAPS-capable devices and the associated MAPS policies and actions.
1. Right-click a device in the Product List or Connectivity Map and select Fabric Vision > MAPS >
Configure.
The MAPS Configuration dialog box displays ( Figure 772 ).
Sort the contents by clicking the column header. Click the same column header again to
reverse the sort order.
FIGURE 772 MAPS Configuration dialog box
2. Review the MAPS data:
• MAPS policies list — Lists the MAPS-capable devices and associated policies and actions.

SAN/Fabric/Switch — All fabrics that contain MAPS-capable switches. You can expand
the fabric node to view switches under each fabric. MAPS policies deployed to the
switch display under the switch node.

Policies — Policies available on the associated switch. The active policy on the switch
displays in the cell adjacent to the associated switch.

RAS Log Event — If check mark displays, logs a RAS event when triggered.

SNMP Trap — If check mark displays, sends an SNMP trap event when triggered.

Fence — If check mark displays, fences the offending port when triggered.

E-mail — If check mark displays, sends an e-mail notification when triggered.