Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 323)

258 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Authentication Server Groups on the Management server
7
4. Review the password policy violator details.
The View Policy Violators dialog box includes the following details:
• User ID — Displays the identifier of the user who violated the password policy.
• Full Name — Displays the full name of the user who violated the password policy.
• Reason — Displays the reason the user violated the password policy.
5. Click Close on the View Policy Violators dialog box.
6. Click Close on the Users dialog box.
Authentication Server Groups on the Management server
NOTE
You must have User Management Read and Write privileges to map roles and AORs to Active
Directory (AD) groups.
NOTE
You must configure an Lightweight Directory Access Protocol (LDAP) server as the primary
authentication server and set Authentication Server Groups as the authorization preference (refer
to
“Configuring LDAP server authentication” on page 495).
Authentication Server Groups enable you to configure user access rights to AD groups (including
users, contacts, computers, and other AD groups) by assigning roles and AORs to groups in the
Management application. LDAP provides user authentication and authorization using the AD
service in conjunction with LDAP on the switch.
Assigning roles and AORs to an AD group
Using Authentication Server Groups, you assign users to groups within the LDAP server, and assign
roles and AORs to the groups within the Management application.
To assign roles and AORs to an AD group, complete the following steps.
1. Select Server > Users.
The Users dialog box displays.
2. Click the Authentication Server Groups tab.