Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1566)

Brocade Network Advisor SAN + IP User Manual 1519
53-1002949-01
IP historical performance monitoring
43
• Source Defined - Whether or not the information source (product or port) is defined (Yes) or not
configured (No).
• System Collectors - Whether or not this is a system data collector. Refer to the following for
more information:
- “Editing system collectors” on page 1517
- “Duplicating system data collectors” on page 1527
When you select a listed data collector, The following information is displayed in the Collector
Details field:
• MIB Variables - The MIB variables used (if any).
• Expression - The expression used (if any).
• Source - The defined products used as information sources by this collector.
Enabling a historical data collector
Use the following steps to enable a data collector to collect historical data or disable a data
collector from collecting data.
1. Select an historical data collector on the Historical Data Collectors dialog box.
- If the collector is disabled, the Enable button is active.
- If the collector is enabled, the Disable button is active.
2. Click Enable to enable the collector.
3. Click Disable to disable the collector.
Adding or editing a historical data collector
Use the following procedure to add or edit an historical data collector using the Data Collector
wizard.
NOTE
There are specific options that you can edit for system collectors. Refer to “Editing system collectors”
on page 1517 for details.
1. Select Monitor > Performance > Historical data collectors
The Historical Data Collectors dialog box displays.
2. Perform either of the following steps:
• Select a collector and click the Edit button.
The Data Collector wizard Collector Basics dialog box displays where you can edit values
for the existing collector.
• Click the Add button
The Data Collector wizard Collector Basics dialog box displays where you can add values
for a new collector.