Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 410)

Brocade Network Advisor SAN + IP User Manual 345
53-1002949-01
User-defined performance monitors
8
8. Click Add beneath the Targets table.
The Performance Dashboard Monitor Targets dialog box displays.
Depending on the type of measure you select, you can add IP products/ports, SAN
products/ports, and FCIP tunnels to the list of targets.
If you selected a product measure, continue with step 9 .
If you selected a SAN or IP port measure, continue with step 9 .
If you selected a FC IP port measure, go to step 15 .
9. Click the SAN tab.
10. Select SAN targets from the Available SAN Sources list.
11. Click the right arrow button to move the targets to the Selected Sources list.
12. Click the IP tab.
13. Select IP targets from the Available IP Sources list.
14. Click the right arrow button to move the targets to the Selected Sources list.
15. Select FCIP targets from the Available list.
16. Click the right arrow button to move the targets to the Selected Sources list.
17. Click OK on the Performance Dashboard Monitor Targets dialog box.
The targets display in the Targets list of the Add Performance Dashboard Monitor dialog box.
18. Click OK on the Add Performance Dashboard Monitor dialog box.
The Customize Dashboard dialog box displays with the new monitor in the Performance
Monitors list.
19. Click OK on the Customize Dashboard dialog box.
The Performance Dashboard dialog box displays with the new monitors at the bottom of the
dashboard.
Configuring a user-defined port performance monitor
1. From the Dashboards expand navigation bar, double-click Performance Dashboard.
The Performance Dashboard displays.
2. Click the Customize Dashboard icon.
The Customize Dashboard dialog box displays.
3. Click the Performance tab.
4. Click Add.
The Add Performance Dashboard Monitor dialog box displays.
5. Select the type of monitor you are creating from the Monitor Type - Port area:
• Top N — Select to monitor the top N (number) ports affected by the selected measure.
• Bottom N — Select to monitor the bottom N (number) ports affected by the selected
measure.