Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 1859
1818
Brocade Network Advisor SAN + IP User Manual
53-1002949-01
MAPS actions
50
•
Security tab — Rules defined on this tab measure thresholds at the switch level to detect
out of range security changes.
•
Resource tab — Rules defined on this tab measure thresholds on temperature sensors or
at the chassis level to detect out of range resource usage.
•
FCIP tab — Rules defined on this tab measure thresholds on FCIP circuits to detect out of
range state, utilization, or packet loss.
•
Traffic / Flows tab — Rules defined on this tab measure thresholds on ports in the
configured group to detect out of range link utilization or on flows to detect out of range
flow changes.
Each tab contains the following fields and components:
•
Rules list — Lists the rules defined for the selected policy.
•
Groups/Rules — Displays the default groups (under the System Groups node) and
user-defined groups (under the Custom Groups node) for the selected switch. The
available groups in the Rules table depend on the measure you selected in the Add/Edit
Threshold area. For example, if you selected an SFP measure, only SFP groups become
available. You can only configure a user-defined group on the Port and FCIP tabs. For more
information, refer to
Rules display below the appropriate group node based on rule targets.
•
Monitor Condition — A combination of the measure, time base, and threshold expression
for the rule.
•
Time Base — The duration by which to monitor the measure.
•
Actions check boxes — Actions configured for the rule. Each action has a column and each
action selected for a rule has a check mark. Supported actions include:
•
Status Marginal (switch status)
•
Status Critical (switch status)
•
RAS Log Event
•
Fence (Port Fencing)
•
SNMP Trap
•
•
SFP Marginal (Port SFP status)
4. Click OK on the View Policy dialog box.
5. Click Close on the MAPS Configuration dialog box.