Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1738)

Brocade Network Advisor SAN + IP User Manual 1695
53-1002949-01
Configuration rules
47
Network OS SNMP community strings
configured check Checks whether SNMP community
strings are configured. Yes Matches snmp-server
community private rw
snmp-server
community public No
IronWare OS Interface name check Checks whether the port is named or
not. Yes Matches port-name.* No
IronWare OS VLAN name check Checks whether the VLAN is named or
not. Yes Matches vlan(.)+name(.)+$ No
IronWare OS Super User password
enabled check Checks whether the super user
password is enabled on the device or
not. Yes Matches ^enable
super-user-password No
IronWare OS Password min length
enabled check Checks whether the password
minimum length is enabled or not.
The range allowed is from 8 through
255 characters. Yes Matches ^enable
password-min-length
([8-9]|[1-9][0-9]|1[0-
9][0-9]|2[0-4][0-9]|2
5[0-5])$ No
IronWare OS AAA Console Enabled
check Checks whether the AAA console is
enabled or not Yes Matches ^enable aaa
console$ No
IronWare OS SSH timeout check Checks whether the IP SSH timeout
value has been configured for the
device in the range [1 - 120]. Yes Matches '^ip ssh +timeout
(0*([1-9][0-9]?|1[01]
[0-9]|120))$' No
IronWare OS SSH idle-time check Checks whether the IP SSH
idle-timeout is less than or equal to
10 minutes. Yes Matches ^ip ssh +idle-time
([0-9]|10)$ No
IronWare OS SSH Client Allowed
check Checks to see if the SSH client is
allowed or not. Yes Matches ip ssh +client.* No
RFS with Configuration Auto Install
Disabled Checks whether auto-installation of
the configuration is disabled in a
user-specified profile. This condition
should be used inside the profile
block. If the profile name is not
specified in the configuration or if the
user selects all the profiles (profile.*),
then it will match against the first
available profile. No Matches no autoinstall
configuration No
RFS with Firmware Auto Install
Disabled Checks whether auto-installation of
the firmware is disabled in
user-specified profile. This condition
should be used inside the profile
block. If the profile name is not
specified in configuration or if user
selects all the profiles (profile.*) then
it will match against first available
profile No Matches no autoinstall
firmware No
TABLE 167 Predefined conditions (Continued)
Name Description Use
regular
expression Matches/
Not Matches Configuration Lines in
exact
order