Filtering data by time – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 1523
1476
Brocade Network Advisor SAN + IP User Manual
53-1002949-01
SAN historical performance data
43
4. Select the ports (press Ctrl or Shift and then click to select multiple ports) from which you want
to gather performance data from the Available list and click the right arrow button.
NOTE
Devices with 10GE ports must be running Fabric OS 6.4.1 or later to obtain the correct TE_Port
statistics (TX/RX).
NOTE
Devices with 10GE ports must have the RMON MIB enabled on the switch. For more
information about the rmon collection command, refer to the Fabric OS Converged Enhanced
Ethernet Command Reference.
The selected ports move to the Selected list.
5. Click OK.
Filtering data by time
To filter data for a historical performance graph by time, complete the following steps.
1. Click Monitor > Performance > Historical Graph.
The Historical Performance Graph dialog box displays.
2. Select Custom from the For list.
The Custom Time Frame dialog box displays as shown in
on page 1476. Perform
one of the following steps:
•
Select the Last option and enter the number of minutes, hours, or days that you want
to monitor.
•
Select the From option and enter the start date and time (in MM DD YYYY HH MM
AM/PM format) that you want to monitor.
•
Select the To option and enter the end date and time (in MM DD YYYY HH MM AM/PM
format) that you want to monitor.
FIGURE 637
Custom Time Frame dialog box
3. Click OK.