Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 1686
1642
Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Schedule PoE power deployment
46
FIGURE 716
Schedule PoE On/Off dialog box
4. (Ports only) Select a port from the Port list.
5. Enter a name for the schedule in the Schedule Name field.
6. Enter a description for the schedule in the Description field.
7. Select the Enable check box to enable the schedule.
8. Select the PoE On option to enable PoE.
9. Choose one of the following options to configure the frequency at which deployment runs for
the schedule:
•
To configure deployment to run only once, refer to
“Configuring a one-time deployment
•
To configure hourly deployment, refer to
“Configuring an hourly deployment schedule”
•
To configure daily deployment, refer to
“Configuring a daily deployment schedule”
•
To configure weekly deployment, refer to
“Configuring a weekly deployment schedule”
•
To configure monthly deployment, refer to
“Configuring a monthly deployment schedule”
•
To configure yearly deployment, refer to
“Configuring a yearly deployment schedule”
10. Click Add.
11. Click Close to close the Schedule PoE On/Off dialog box.
12. Click Close to close the Power Center dialog box.