Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 242)

176 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
SAN End node display
6
To reset the Management application to the default display and view settings, complete the
following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select SAN Display in the Category list.
3. Click Reset Display.
4. Click Yes on the reset confirmation message.
The display and view settings are immediately reset to the default display settings (as detailed
in the Default display settings table (
Table 31 ).
5. Click Apply or OK to save your work.
SAN End node display
The connectivity map can be configured to display or not display end nodes. This option enables
you to set the end node display for all newly discovered fabrics. Note that disabling end node
display limits the connectivity map to emphasize switch members only.
Displaying end nodes
To display end nodes when discovering a new fabric, complete the following steps.
1. Select Server > Options.
The Options dialog box displays ( Figure 62 ).
FIGURE 62 Options dialog box (SAN End Node Display pane)
2. Select SAN End Node Display in the Category list.
3. Select the Show connected end nodes when new fabric is discovered check box to display end
nodes on your system.
NOTE
Before changes can take effect, the topology must be rediscovered.
4. Click Apply or OK to save your work.