Creating a network group – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 854
798
Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Layer 3 access control list policy
22
2. Review the List of Network Groups table:
•
Name — The user-defined network group name.
•
Host Names — The name of each host in the network group.
•
Address Range — The range of IP addresses for the network group.
•
Networks — The name of each network in the network group.
•
Network Groups — The name of each network group in the network group.
3. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.
Creating a network group
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
•
“Creating a standard L3 ACL configuration”
•
“Editing a standard L3 ACL configuration”
•
“Copying a standard L3 ACL configuration”
•
“Creating an extended L3 ACL configuration”
•
“Editing an extended L3 ACL configuration”
•
“Copying an extended L3 ACL configuration”
To create a network group, complete the following steps.
1. Click the Network Groups tab.
2. Click Add.
The Add Network Group dialog box displays.
FIGURE 284
Network dialog box, Network Group tab
3. Enter a name for the network group in the Group Name field.