Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 192)

Brocade Network Advisor SAN + IP User Manual 125
53-1002949-01
Individual IP device discovery
4
9. Configure the Read/Write credentials by completing the following steps.
a. Click the Read/Write Credentials tab.
FIGURE 43 Read/Write credentials
b. Enter the unique user name in the Login Prompt User Name field.
The user name can be from 1 through 200 characters long, case sensitive, and allows all
printable ASCII characters.
c. Enter the password in the Login Prompt Password field.
The password can be from 1 through 200 characters long, case sensitive, and allows all
printable ASCII characters. The password displays as asterisks. Not applicable to DCB
devices.
10. Click OK on the Add product dialog box.
The Discover Setup - IP dialog box displays with the added IP device in the Discovered Products
table.
11. Click Close to close the Discover Setup - IP dialog box.
Editing IP device discovery
NOTE
Although, you can configure third-party product password settings through discovery, the
Management application ignores these third-party product settings.
To edit one or more IP devices, complete the following steps.
1. Select Discover > IP Products.
The Discover Setup - IP dialog box displays.
2. Select one or more IP devices you want to edit in the Discovered Products table.
Select multiple devices by holding down the CTRL key and clicking more than one device.
NOTE
You cannot edit IronWare and Network OS devices at the same time.
NOTE
You can only edit multiple Network OS devices that are running the same firmware level.