Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1404)

Brocade Network Advisor SAN + IP User Manual 1355
53-1002949-01
VLL manager
37
Deploying VLL properties using the VLL Manager
1. From the Deployment Properties pane of the VLL Configuration Wizard, under Persistence
Properties, chose one of the following:
- Do not Save to Flash or Reload - Use this option if you want to update the running
configuration. The payload configuration is not saved to the device flash memory, nor is
the device rebooted when the VLL configuration is deployed.
- Save to Flash - Use this option if you want to make the payload configuration permanent in
the device flash memory and saved to the running configuration. This is equivalent to
entering a write memory command. The payload configuration is applied to the device
when the device reboots.
- Save to Flash and Reload - Use this option if you want to save the payload configuration to
the device flash memory and reboot the device. This is equivalent to entering the write
memory and reload commands. The availability of this option depends on your user
privileges.
2. Determine if you want to save the payload configuration in the Management application. If this
is a one-time deployment, select One time deployment, do not save configuration. If you want
to save the configuration for future deployment, select Save configuration, and enter a
configuration name and description.
3. Click Next.
If you did not select Save configuration on the Deployment Properties dialog box, the Summary
dialog box displays (
Figure 594 ), and you may skip to step 1 .
If you selected Save configuration on the Deployment Properties dialog box, the Deployment
Schedule dialog box displays (
Figure 593 ). Refer to “Scheduling deployment using the VLL
Manager” on page 1356.
FIGURE 593 VLL configuration wizard Deployment Schedule dialog box