Hyperedge – stack enable 1, Hyperedge – stack disable 1, Hyperedge – stack port creation 1 – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 2040: Hyperedge – stack port deletion 1, Hyperedge – stack trunk creation 1
Brocade Network Advisor SAN + IP User Manual
2001
53-1002949-01
CLI Templates
G
•
IronWare OS VLAN – Configure virtual routing interface . . . . . . . . . . . . 2013
•
IronWare OS VLAN – Enable Spanning Tree Protocol on IOS VLAN . . . . 2013
•
IronWare OS VLAN – Disable Spanning Tree Protocol on IOS VLAN. . . . . 2014
•
Network OS VLAN – VLAN Interface Creation . . . . . . . . . . . . . . . . . . . . . . 2014
•
Network OS VLAN – VLAN Interface Deletion . . . . . . . . . . . . . . . . . . . . . . 2014
•
Network OS VLAN – Layer2 Switch Port Configuration . . . . . . . . . . . . . . . 2014
•
Network OS VLAN – Trunk Interface Configuration with allowed VLAN list 2014
•
Network OS VLAN – Configure Layer2 Interface as an Interface Port . . . 2014
•
Network OS VLAN – Native VLAN Configuration . . . . . . . . . . . . . . . . . . . . 2014
•
Network OS VLAN – Disable Native VLAN Configuration . . . . . . . . . . . . 2015
•
Network OS VLAN – Access Interface Configuration. . . . . . . . . . . . . . . . 2015
•
Network OS VLAN – Disable Access Interface Configuration . . . . . . . . . 2015
•
Network OS VLAN – Enable Spanning Tree Protocol on NOS VLAN . . . . 2015
•
Network OS VLAN – Disable Spanning Tree Protocol on Network OS VLAN 2015
TABLE 14
HyperEdge – Stack Enable
Feature
Description
CLI Commands
HyperEdge To enable stacking mode.
stack enable
TABLE 15
HyperEdge – Stack Disable
Feature
Description
CLI Commands
HyperEdge To disable stacking mode.
stack disable
TABLE 16
HyperEdge – Stack Port Creation
Feature
Description
CLI Commands
HyperEdge To create stacking ports.
stack unit $<STACKID|INTEGER>
stack-port $<STACKID1/SLOT/PORT|STRING>
$<STACKID2/SLOT/PORT|STRING>
TABLE 17
HyperEdge – Stack Port Deletion
Feature
Description
CLI Commands
HyperEdge To delete stacking ports.
stack unit $<STACKID|INTEGER>
no stack-port $<STACKID1/SLOT/PORT|STRING>
$<STACKID2/SLOT/PORT|STRING>
TABLE 18
HyperEdge – Stack Trunk Creation
Feature
Description
CLI Commands
HyperEdge To create stacking trunks.
stack unit $<STACKID|INTEGER>
stack-trunk $<SRC_STACKID/SLOT/PORT|STRING> to
$<DST_STACKID/SLOT/PORT|STRING>