Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 841)

Brocade Network Advisor SAN + IP User Manual 785
53-1002949-01
Layer 3 access control list policy
22
6. To delete an existing ACL entry, select the ACL you want to delete in the ACL Entries list and
click the left arrow button.
7. Use the Up and Down arrow buttons to rearrange the ACLs in the ACL Entries list.
8. Select an ACL in the ACL Entries list and click View to the L3 ACL Advanced Settings dialog box
for the ACL.
9. View the advanced settings for an ACL by selected the ACL in the ACL Entries list and clicking
View.
The L3 ACL Advanced Settings dialog box displays.
10. Click Close on the L3 ACL Advanced Settings dialog box to close.
11. Click OK on the Duplicate - L3 ACL (IPv 6) Configuration dialog box.
The new ACL displays in the ACLs list.
12. To set the configuration type and operations, refer to “Configuring the ACL configuration type
and operations” on page 788.
13. (Ethernet routers only) To set the hit statistics duration, refer to “Configuring hit statistics” on
page 788.
14. To deploy the configuration, click OK on the Device_Name - L3 ACL Configuration dialog box.
The Deploy to Products - L3 ACL dialog box displays. To deploy the configuration, refer to
“Security configuration deployment” on page 819.
Deleting a L3 ACL configuration
NOTE
You cannot delete an IPv6 L3 ACL that is bound to a port.
To delete an ACL configuration, complete the following steps.
1. Select the device and select Configure > Security > Layer 2 ACL > Product.
The Device_Name - L3 ACL Configuration dialog box displays.
2. Select the ACL you want to delete in the ACLs list and click Delete.
3. Click Yes on the confirmation message.
4. Click OK on the Device_Name - L3 ACL Configuration dialog box.
The Deploy to Products - L3 ACL dialog box displays. To save the configuration, refer to “Saving
a security configuration deployment” on page 821
Assigning a L3 ACL configuration to an interface
To assign L3 ACL configuration to a interface, complete the following steps.
1. Select Configure > Security > L3 ACL > Port.
The Port Selection - L3 ACL dialog box displays.
2. Select a port in the Available Ports list and click the right arrow button.