Configuring address ranges, Configuring address, Ranges – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 171
104
Brocade Network Advisor SAN + IP User Manual
53-1002949-01
IP discovery profiles
4
Configuring address ranges
NOTE
DCB devices discovered through Fabric discovery (from the SAN tab) are automatically added to IP
discovery during rediscovery.
To include and exclude addresses from profile discovery, complete the following steps.
1. Select Discover > IP Products.
The Discover Setup - IP dialog box displays.
2. Click the Profiles tab
3. Select the profile you want to edit in the Discovery Profiles table and click the Address Ranges
tab.
4. Include an address range by choosing one of the following options:
•
To include an address range using the CIDR subnet format, refer to
•
To include an address range using the subnet format, refer to
•
To include an address range using the address range format, refer to
•
To include all addresses, select all addresses from the Entry Type list.
5. Select the Also perform ping sweep check box to perform ping sweep on the address range.
6. Click the right arrow button to add the address range to the Included IP Addresses list.
7. Exclude an address range by choosing one of the following options:
•
To exclude an address range using the CIDR subnet format, refer to
•
To exclude an address range using the subnet format, refer to
•
To exclude an address range using the address range format, refer to
NOTE
DCB products discovered through Fabric discovery (on the SAN tab) cannot be excluded.
NOTE
To exclude a VCS fabric, you must add all members of the VCS fabric to the exclude list.
8. Click the right arrow button to add the address range to the Excluded IP Addresses list.
9. Click Apply to save your changes.
10. Click Close to close the Discover Setup - IP dialog box.
11. Click Yes on the confirmation message.