Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1898)

Brocade Network Advisor SAN + IP User Manual 1857
53-1002949-01
Generating SAN zoning reports
52
h. Click Apply.
The selected report automatically displays in the View Reports dialog box.
NOTE
Hyperlinks in reports are active only if the source data is available.
To print the selected report, refer to “Printing SAN reports” on page 1854.
To export the selected report, refer to “Exporting SAN reports” on page 1854.
To delete the selected report, refer to “Deleting SAN reports” on page 1855.
4. Click the close button (X) to close the View Reports dialog box.
5. Click the close button (X) to close the HIstorical Performance Table dialog box.
For more information about performance, refer to “Performance Data” on page 1459.
Generating SAN zoning reports
The Management application enables you to generate a report for the current zone DB in the
fabric. To generate a report for the edited zone DB, you must save it to the fabric first. Make sure no
one else is making changes to the same area prior to submitting or your changes may be lost.
To generate zoning reports, complete the following steps.
1. Select Configure > Zoning or right-click the device and select Zoning.
The Zoning dialog box displays.
2. Click Report.
3. Click OK on the message.
The selected report automatically displays in the View Reports dialog box.
NOTE
Hyperlinks in reports are active only if the source data is available.
To print the selected report, refer to “Printing SAN reports” on page 1854.
To export the selected report, refer to “Exporting SAN reports” on page 1854.
To delete the selected report, refer to “Deleting SAN reports” on page 1855.
4. Click Close to close the View Reports dialog box.
5. Click Yes on the “are you sure you want to close” message.
For more information about zoning, refer to “Zoning” on page 1045.