Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1718)

Brocade Network Advisor SAN + IP User Manual 1675
53-1002949-01
Adding a policy monitor
47
e. Enter the initiator port limit in the Initiator Port Limit field.
The default recommended threshold ratio is 20:1 (20 initiator ports to 1 target port).
Therefore, if the ratio for the storage port is equal to or higher than 20:1, the policy
monitor considers it as a violation and logs it in the report.
f. Select the Check that all profiles are the same on each RBridge in an Ethernet fabric
check box to determine if all RBridge profiles in an Ethernet fabric are the same.
For more information about this check and a fix for rule violations, refer to “Fabric policy
monitors” on page 1664.
g. Select the fabrics to which you want to apply this policy in the Available Fabrics list and
click the right arrow button.
NOTE
You can use the All Fabrics target in the Available Fabrics table for future provisioning.
Select All Fabrics and click the right arrow button to apply this policy to all discovered
fabrics.
The selected fabrics display in the Selected Fabrics list.
7. To set policy monitors for switches, select the Switch/Router Checks tab ( Figure 724 ) and
complete the following steps.
FIGURE 724 Add Policy Monitor dialog box, Switch/Router Checks tab