Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 240)

174 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
SAN display settings
6
5. Browse to the backup location.
Browse to the location specified in the Output Directory field on the Options dialog box -
Backup pane.
6. Click Restore.
Upon completion, a message displays the status of the restore operation. Click OK to close the
message and the Server Management Console. For the restored data to take effect, re-launch
the Configuration Wizard using the instructions in
“Launching the Configuration Wizard” on
page 5.
Restoring data to a new server
NOTE
The restore data files must use the exact directory structure as the backup directory structure (refer
to
“Back up directory structure overview” on page 168).
If your Management application server fails and you must recover information to a new server,
restore the data (Refer to
“Restoring data” on page 173 for complete instructions).
SAN display settings
You can configure the display for FICON and reset the display to the default settings.
Setting your FICON display
FICON display setup rearranges the columns of any table that contains end device descriptions to
move the following columns to be the first columns: Attached Port#, FC Address, Serial #, Tag,
Product Type, Model, Vendor, Port Type, and WWN.
NOTE
You cannot set the FICON display for Professional and Professional Plus software.
To set the FICON display, complete the following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select SAN Display in the Category list.
The SAN Display pane displays.