Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 197)

130 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Individual IP device discovery
4
11. Change the Read Only credentials by completing the following steps.
NOTE
These credentials are not applicable for DCB, VDX, or VCS devices.
a. Click the Read Only Credentials tab.
FIGURE 48 Read Only credentials
a. Change the unique user name in the Login Prompt User Name field.
The user name can be from 1 through 16 characters long, case sensitive, and allows all
printable ASCII characters.
b. Change the password in the Login Prompt Password field.
The password can be from 8 through 16 characters long, case sensitive, and allows all
printable ASCII characters. The password display as asterisks.
c. Change the unique user name in the Enable Prompt User Name field.
The user name can be from 1 through 16 characters long, case sensitive, and allows all
printable ASCII characters.
d. Change the password in the Enable Prompt Password field.
The password can be from 8 through 16 characters long, case sensitive, and allows all
printable ASCII characters. The password display as asterisks.
12. Click OK on the Edit product dialog box.
The Discover Setup - IP dialog box displays with the updated IP device in the Discovered
Products table.
13. Click Close to close the Discover Setup - IP dialog box.