Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 870)

814 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Media Access Control (MAC) filter management
22
4. Click OK on the MAC Filter Saved Configurations dialog box.
The Device_Name - MAC Filter Configuration dialog box displays with the selected MAC filters in
the MAC Filters table. If you selected a saved deployment configuration, all MAC filters
associated with the saved deployment configuration display in the MAC Filters table.
5. Click OK on the Device_Name - MAC Filter Configuration dialog box.
The Deploy to Products - MAC Filter dialog box displays. To deploy the configuration, refer to
“Security configuration deployment” on page 819.
Editing a MAC filter
To edit a MAC filter configuration, complete the following steps.
1. Select Configure > Security > MAC Filter > Product.
The Device_Name - MAC Filter Configuration dialog box displays.
2. Select the configuration you want to edit in the MAC Filters table and click Edit.
The Edit MAC Filter dialog box displays.
FIGURE 292 Edit MAC Filter dialog box
3. Change the description of the MAC filter in the Description field.
4. Select Permit or Deny from the Action list.
5. In the Source Address list, select one of the following options:
• Any
• MAC
Selecting MAC enables the Source Address and Source Mask fields.
a. Enter the source MAC address on which the configuration filters traffic in the Source
Address field.
b. Enter the mask associated with the source MAC address in the Source Mask field.