Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 868)

812 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Media Access Control (MAC) filter management
22
FIGURE 290 Add MAC Filter dialog box
3. Enter a MAC filter number in the MAC Filter # field.
MAC filter numbers range from 1 through 1024.
4. (Optional) Enter a description of the MAC filter in the Description field.
The description is saved to the Management application database only. It is not saved to the
switch.
5. Select Permit or Deny from the Action list.
6. In the Source Address list, select one of the following options:
• Any
• MAC
Selecting MAC enables the Source Address and Source Mask fields.
a. Enter the source MAC address on which the configuration filters traffic in the Source
Address field.
b. Enter the mask associated with the source MAC address in the Source Mask field.
7. In the Destination Address list, select one of the following options:
• Any
• MAC
Selecting MAC enables the Destination Address and Destination Mask fields.
a. Enter the destination MAC address on which the configuration filters traffic in the
Destination Address field.
b. Enter the mask associated with the destination MAC address in the Destination Mask
field.
8. In the Ethernet Type list, select one of the following to specify the Ethernet type being
transferred in the Ethernet frame:
• etype — EtherType
• llc — IEEE 802.2 Logical Link Control
• snap — Subnetwork Access Protocol
• none — no type