Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 817)

Brocade Network Advisor SAN + IP User Manual 761
53-1002949-01
Layer 2 access control list management
22
Fabric OS Layer 2 ACL configuration
This section provides procedures for configuring a standard for extended Layer 2 ACL on a device,
assigning the Layer 2 ACL to an interface, as well as clearing Layer 2 ACL assignments from a
device.
Creating a standard Layer 2 ACL configuration (Fabric OS)
To create a standard Layer 2 ACL configuration, complete the following steps.
1. Select the device and select Configure > Security > Layer 2 ACL > Product.
The Device_Name - Layer 2 ACL Configuration dialog box displays.
2. Select New from the Add list.
The Device_Name - Layer 2 ACL Configuration dialog box displays.
FIGURE 267 Device_Name - Layer 2 ACL Configuration (Standard) dialog box
3. Select Standard from the Type list.
4. Enter a name for the ACL in the Name field.
5. Enter a sequence number for the ACL in the Sequence field.
6. Select Permit or Deny from the Action list.
7. In the Source list, select one of the following options:
• Any
• MAC
Selecting MAC enables the Source field. Enter the source MAC address on which the
configuration filters traffic in the Source field.
8. Select the Count check box to enable counting.
Count specifies the number of times the ACL rule is applied.
9. Click the right arrow button.
The new ACL entry displays in the ACL Entries list. To create additional ACL entries, repeat
step 3 through step 9 .