Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 769)

712 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Switch, port, and LAG deployment
20
• Re-authentication Interval - The number of seconds between re-authentication attempts.
The value range is 1 to 4294967295. The default value is 3600 seconds. This feature is
not dependent on the re-authentication state being enabled.
• Port Control - Select an authorization mode from the list to configure the ports for
authorization. Options include auto, force-authorized, or force-unauthorized and the
default value is auto.
6. When you have finished the configuration, click OK to launch the Deploy to Ports dialog box.
Refer to “Switch, port, and LAG deployment” on page 712 for more information.
Switch, port, and LAG deployment
The Deploy to Products, Deploy to Ports, and Deploy to LAGs dialog boxes provide the flexibility to
commit DCB configurations either right away or at a scheduled time. These dialog boxes also allow
you to commit the switch-level configuration changes to one or more target switches.
NOTE
Deployment from the Management application to a Network OS device is not supported.
Deploying DCB product, port, and LAG configurations
The switch, port, and LAG deployment dialog boxes provide common deployment options, save
configuration options, and schedule options. Depending on which product, port, or LAG you select,
the Deploy to Products, Deploy to Ports, or Deploy to LAGs dialog box displays upon deployment.
1. Select Configure > DCB from the menu bar.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select a switch, port, or LAG, and click Edit.
3. Configure the switch, port, or LAG. When you have finished the configuration, click OK to
launch the appropriate dialog box. Refer to Figure 251 , Figure 252 , and Figure 253 .