Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 785)

728 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Network OS switches in VCS mode
20
Viewing FCoE parameters on the Network OS switch LAG
Table 106 describes the parameters that displays on the View LAG dialog box - FCoE tab.
NOTE
The Interface mode is None and the L2 mode is empty for the FCoE-provisioned LAG.
Viewing LLDP-DCBX parameters on the Network OS switch LAG
Table 107 describe the parameters that displays on the View LAG dialog box - LLDP-DCBX tab.
TABLE 106 FCoE configuration parameters on VCS switch
Field/Component Description
FCoE Map
Note: The default FCoE map contains
both the default Fabric map and the
default DCB map. Displays the following information about the FCoE map:
•
Fabric Map — The name of the Fabric map. The default Fabric map
consists of virtual fabric and FCoE VLAN-related information.
•
DCB Map — The name of the DCB map.
Fabric Map Displays the following information about the Fabric map:
•
VLAN ID — The FCoE VLAN identifier associated with the Fabric
map.
•
FCMAP — The unique MAC address prefix an FCoE Forwarder (FCF)
uses to identify FCoE traffic on a particular FCoE VLAN.
•
Fabric ID — The Fabric identifier.
•
Priority — The FCoE priority forwarding class to queue mapping.
•
FIP Advertisement Interval — Displays the frequency, in seconds, at
which FIP advertisements are set.
•
FIP Keep Alive Timeout — Displays whether the Keep Alive Timeout
feature is enabled. The feature represents the amount of time (in
seconds) to keep keep-alive connections active.
TABLE 107 LLDP-DCBX parameters on the Network OS switch LAG
Field/Component Description
Enable LLDP-DCBX check box Indicates whether LLDP-DCBX feature is enabled or disabled and
whether the global configuration or a specified LLDP profile has been
assigned to the vLAG ports.
LLDP Profile Parameters Displays the following LLDP profile parameters:
•
Name — The name of the LLDP profile.
•
Description — A description of the LLDP profile.
•
Mode — The Transmit and Received mode. Options include Both
Transmit and Received, Transmit Only, or Receive Only.
•
Hello — The hello interval time (in seconds) for the bridge. The value
range is from 4 through 180 and the default value is 30.
•
Multiplier — The multiplier (in seconds). The value range is from 1
through 10 and the default is 4.
•
Advertise — The profiles that are configured to advertise. The profile
options are as follows:
-
DCBX
-
FCoE Application
-
FCoE Logical Link