Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1567)

1520 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
IP historical performance monitoring
43
FIGURE 656 Data Collector wizard Collector Basics pane
3. Enter a descriptive name for the data collector in the Name field.
4. Use the Polling Interval list to set the polling interval.
The choices are 1 minute, 5 minutes, 10 minutes, 15 minutes, and 30 minutes.
5. Select the Target Type.
• If you select Product level, SNMP data is collected at the product (device) level.
• If you select Port level, SNMP data is collected at the port level.
6. Select the Status of the collector.
• If you select Enabled, the data collector starts collecting data immediately.
• If you select Disabled, the data collector stops collecting data.
• If you select Schedule, you may set up a time schedule for running the data collector.
The following become active when you select Schedule:
• Frequency - This list allows you to run the data collector on a Yearly, Monthly, Weekly, Daily,
Hourly, or One Time basis. Appropriate options are displayed allowing you set a start time
and duration for data collection.
• If you select Yearly, or One Time, the Time (hh:mm) and Date selectors display.
• If you select Monthly, the Time (hh:mm) and Day of the Month selectors display.
• If you select Weekly, the Time (hh:mm) and Day of the Week selectors display.
• If you select Daily, the Time (hh:mm) selector displays.