Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 1402
Brocade Network Advisor SAN + IP User Manual
1353
53-1002949-01
VLL manager
37
a. From the Tag Mode list, select one of the following:
•
Tagged: If the endpoint is a tagged port, the device transmits the packet with the
specified VLAN ID and forwards it out the specified interface.
•
Untagged: If the endpoint is an untagged port, the device removes any VLAN ID before
transmitting it out the specified interface.
b. For tagged ports only, enter a VLAN ID for the service provider end point tag in the Outer
VLAN ID field.
Packets with this VLAN ID are transmitted out the specified interface. If you configure dual
tagged (inner and outer VLAN ID) endpoints, make sure you meet the following
requirements:
•
Requires an Ethernet router, Core router, or Backbone router with firmware version 5.0
and later.
•
You can only define a specific Inner VLAN ID/Outer VLAN ID combination once for all
VLL or VPLS instances.
•
You can only define one dual tagged endpoint per port.
•
You cannot define a dual tagged endpoint on a port if there is a 802.1ag configuration
defined on the port.
c. For tagged ports only, enter a VLAN ID for the customer end point in the Inner VLAN ID
field.
Packets with this VLAN ID are transmitted out the specified interface.
d. From the COS list, select a COS for the port.
This field applies only to local VLLs.
5. Click Apply.
If any of the endpoints
6. Click Next.
The VLL Configuration wizard Deploy Target Actions dialog box displays (
).
FIGURE 591
VLL Configuration wizard Deploy Target Actions dialog box