Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1808)

1766 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Event custom reports
48
FIGURE 765 Add/Edit Report Definition dialog box - Time Settings tab
4. Choose between relative time (the default) and absolute time.
- Click Relative Time if you want to filter traffic based on when the report is generated, and
then select a relative time from the Range list. Relative time is calculated based on the
date and time the report is generated.
- Click Absolute Time if you want to filter traffic sent at a specific date and time.
a. Select the specific start date from the Start Date list.
b. Select the specific hour time for the start time from the Start Time list, and select AM
or PM.
c. Select the specific end date from the End Date list.
d. Select the specific hour for the end time from the End Time list, and select AM or PM.
5. Click OK to save the definition, or click Run to launch the report.