Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1590)

Brocade Network Advisor SAN + IP User Manual 1543
53-1002949-01
IP sFlow configuration
43
2. Click Next.
The Interface Payload - sFlow Settings dialog box displays.
FIGURE 675 Interface Payload - sFlow Settings dialog box
3. Under Global Settings, select Enable to have the sFlow report enabled when it is deployed.
Select Disable to deploy the sFlow report as initially disabled.
4. Use the Rate Sampling selector to choose either Adaptive or Custom sampling.
If you choose Adaptive, the management server selects the sampling interval and traffic
sampling rate. The sampling rate is the ratio between the total number of incoming packets
and the number of flow samples taken at the product level. When Adaptive is chosen, the
sampling rate is based on interface speeds as shown in
Table 145 on page 1543.
TABLE 145 Interface Payload
Interface Speed Sampling rate
10 Mbps 256
100 Mbps 512
1 Gbps 1024
10 Gbps 2048
100 Gbps 8192