Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1721)

1678 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Adding a policy monitor
47
c. Select the Check for connections through two fabrics to each target LUN check box to
determine if there are redundant connections between the host group and the target LUN.
For more information about this check and a fix for rule violations, refer to “Host policy
monitors” on page 1668.
d. Select the hosts to which you want to apply this policy in the Available Hosts list and click
the right arrow button.
NOTE
You can use the All Host target in the Available Hosts list for future provisioning. Select All
Hosts and click the right arrow button to apply this policy to all discovered hosts.
The selected hosts display in the Selected Hosts list.
9. To set policy monitors for the Management application ( Figure 726 ), complete the following
steps.
FIGURE 726 Add Policy Monitor dialog box, Management Checks tab
a. Select the Management Checks tab.
b. Select the Check to see if the server backup is enabled and working check box to
determine the following configurations:
• Backup enabled for the Management application server.
• Backup output directory is accessible and writable.
This policy only applies to scheduled backup, not manual (on demand) backup.
For more information about this check and a fix for rule violations, refer to “Management
policy monitor” on page 1670.
10. Click OK on the Add Monitor dialog box.
The Policy Monitor dialog box displays with the new policy monitor in the Monitors list.
11. Click Close on the Policy Monitor dialog box.