Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1633)

Brocade Network Advisor SAN + IP User Manual 1587
53-1002949-01
Provisioning flows
44
FIGURE 694 Select Device Ports dialog box. (Products and Ports selected)
Select products and ports under the Available Products panel and move to the Selected
Products panel using the right arrow. In the Selected Products panel you can select to Use
Any Port (*) in these products or Use Selected Ports. If you choose to use selected ports,
select a specific port under the Selected Products panel.
Move products and ports from the Selected Products panel back to the Available Products
panel by selecting them and using the left arrow.
Selecting OK on the Select Device Ports dialog box enters selected product WWNs or port
addresses into the Source and Destination fields on the Add Flow Definition dialog box.
3. On the Add Flow Definition dialog box, select <swap> if you want to swap source and
destination device identifications.
4. Select Port (slot/port) or D,I format.(domain ID, port number) for entering Switch Ingress and
Egress identification.
5. Use the following options to enter identification in the Switch Ingress and Egress fields.
- Type identifiers in the fields (entering an asterisk denotes any port) into the fields.
- Click the ellipsis button to the right of the Ingress and Egress fields to display the Select
Switch Ports dialog box (
Figure 695 ). Use this dialog box to select switch ports from
discovered fabrics.