Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1302)

1252 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Creating a payload configuration
33
9. (Optional) Enter the following information if you want the Management application to run and
save a report before or after this configuration is deployed to the device.
a. Select the Pre-Deployment check box if you want the Management application to run and
save a report before this configuration is deployed.
b. Select the Post-Deployment check box if you want the Management application to run and
save a report after this configuration is deployed.
c. From the CLI Template list, select the template that contains the show commands that are
executed before or after this configuration is deployed to the target.
d. If you selected the Post-Deployment check box, and you want the Management application
to wait a few seconds after this deployment before proceeding to the post-deployment,
indicate the delay on the Post-Deployment Delay slider.
10. Select whether you want to save this configuration.
• Select One-time deployment, do not save configuration if you want to deploy the
configuration, but not save it.
• Select Save configuration if you want the Management application to save the
configuration.
If you select this option, enter a name for the configuration and an optional description in
the Name and Description fields.
11. Click Next.
If you selected Save configuration, the Deployment Schedule pane displays, as shown in
Figure 540 . Continue with step 12 .
FIGURE 540 Configuration dialog box - Deployment Schedule pane