Deleting a maintenance association, Deleting a maintenance, Association – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 1436
Brocade Network Advisor SAN + IP User Manual
1387
53-1002949-01
802.1ag Connectivity Fault Management
37
•
To send a loopback message to a specific MEP or MIP in the domain, refer to
•
To send a linktrace message to a specific MEP or MIP in the domain, refer to
4. Click Close on the Configure 802.1ag CFM dialog box.
Deleting a maintenance association
You can access 802.1ag CFM from the following features:
•
VPLS Manager (requires the IP - MPLS – VLL prvilege with read-write or read-only permission)
•
VLL Manager (requires the IP - MPLS – VPLS prvilege with read-write or read-only permission)
•
VLAN Manager (requires the VLAN Manager prvilege with read-write or read-only permission)
NOTE
802.1ag CFM is only supported on IronWare Ethernet Routers devices running firmware release 5.2
or later.
NOTE
Only maintenance domains that are not linked to other associations will be deleted.
To delete a maintenance association, complete the following steps.
1. Right-click a device and select 802.1ag CFM.
The Configure 802.1ag CFM dialog box displays.
2. Select one or more maintenance associations you want to delete in the Maintenance
Association Details table.
3. Click Delete.
A confirmation message displays with a Delete the maintenance domain? check box. Make
sure that the check box is selected.
4. Click Yes on the confirmation message.