Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 844)

788 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Layer 3 access control list policy
22
5. To clear outbound messages, complete the following steps:
a. Select the Outbound check box.
b. Select the Clear ACL Assignment option.
6. Click OK on the Device_Name - Port_Number - Layer 3 ACL Configuration dialog box.
The Deploy to Ports - L3 ACL dialog box displays. To deploy the configuration, refer to “Security
configuration deployment” on page 819
Configuring the ACL configuration type and operations
To configure the ACL configuration type and operation, complete the following steps.
1. Select the configuration type by choosing one of the following options:
• Incremental — Deploys add and delete operations. During deployment, the Management
application checks all ACLs to determine if the ACL name or number matches any ACL
number already deployed on a switch.
If the ACL name or number matches, the following actions occur:

Add operation — The ACL on the switch is overwritten by the one in configuration
during deployment.

Delete operation — Deletes the ACL from the switch during deployment.

No Action operation — Skips the ACL during deployment; however, if you save the
deployment the ‘no action’ ACL remains part of the configuration and can be added or
deleted at a later date.
If the ACL name or number does not match, the following actions occur:

Add operation — The ACL is appended on the switch.

No Action operation — Skips the ACL during deployment; however, if you save the
deployment the ‘no action’ ACL remains part of the configuration and can be added or
deleted at a later date.
• Overwrite — Only deploys add operations. During deployment, the Management
application clears all ACLs currently on the switch and then applies the new configuration.
2. (Ethernet routers only) To set the hit statistics duration, refer to “Configuring hit statistics” on
page 788.
3. To deploy the configuration, click OK on the Device_Name - L3 ACL Configuration dialog box.
The Deploy to Products - L3 ACL dialog box displays. To deploy the configuration, refer to
“Security configuration deployment” on page 819.
Configuring hit statistics
To configure hit statistics, complete the following steps.
1. Select an Ethernet router product and select Configure > Security > L3 ACL > Product.
The Device_Name - L3 ACL Configuration dialog box displays.
2. Select a duration (1 second, 1 minute, 5 minutes, or Cumulative) from the Hit Stats Duration
list.