Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 151)

84 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
IP SNMP credentials
4
4. Enter a unique label to identify the community string in the Display Label field of the Add/Edit
Read-Write Community Strings list.
This label can be from 1 through 16 characters long, case sensitive, and allows all printable
ASCII characters.
5. Enter the unique community string in the Community Strings field.
The community string can be from 1 through 16 characters long, case sensitive, and allows all
printable ASCII characters. The string displays as asterisks.
6. Click the right arrow button to add the read-write community string to the Selected Read-Write
Community Strings list.
NOTE
Discovery uses the read-write community string to detect both SNMP read and SNMP write
community strings.
If the devices use multiple community strings, use the Up or Down buttons to place the most
commonly used community string at the top of the Selected Read-Write Community Strings list
to make discovery run more efficiently.
NOTE
If the Selected Read-Write Community Strings list does not contain any community strings, the
Management application uses the "public" and "private" community strings.
7. Click Apply to save your work.
8. Click Close to close the Discover Setup - IP dialog box.
9. Click Yes on the confirmation message.
Adding SNMPv3 credentials
To add SNMPv3 read-write credentials, complete the following steps.
1. Select Discover > IP Products.
The Discover Setup - IP dialog box displays.
2. Click the Global Settings tab.
3. Click the SNMP tab.
FIGURE 18 SNMPv3 credentials