Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1401)

1352 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
VLL manager
37
Configuring devices using the VLL Manager
1. From the Product Configuration pane of the VLL Configuration Wizard, click each device entry.
The last discovered CoS and MTU settings for the device are displayed in the Discovered area.
You can modify the settings under the Configured area.
2. Enter values for the following:
- COS - From the drop down list, select the Class of Service (COS) you want to assign to this
instance. Packets that go through this instance are assigned this instance. Select 0 - 7.
- MTU - Enter a Maximum Transmission Unit (MTU) for the device. MTU is the size of the
largest data packet that can pass along a device. MTU must be 64 - 90.
- Configured Peers - The Peers table shows the peer of the selected device. You can select
the IP address of the peer by clicking the drop down arrow for Peer IP address. By default,
the ingress IP address of a tunnel is selected.
3. Click Next.
The VLL Configuration wizard Port Configuration dialog box displays ( Figure 590 ).
FIGURE 590 VLL Configuration wizard Port Configuration dialog box
The last discovered port settings for VLLs are displayed in the Discovered Endpoint Settings
table. You can make changes to the settings in the Configured Endpoint Settings table.
4. To configure port settings for a port that has not been configured, select a port from the
interfaces tree and click Add to add a row to the Configured Endpoint Settings table.
NOTE
You must configure two endpoints.
Provide the following information: