Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 822)

766 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Layer 2 access control list management
22
5. To add a new ACL rule, complete step 4 through step 12 in “Creating an extended Layer 2 ACL
configuration (Fabric OS)” on page 763.
The new ACL entry displays in the ACL Entries list. To add additional ACL entries, repeat step 5 .
6. To delete an existing ACL rule, select the rule you want to edit in the ACL Entries list and click
the left arrow button.
7. Click OK on the Duplicate - Layer 2 ACL Configuration dialog box.
The new ACL displays in the ACL Entries list. To copy additional ACLs, repeat step 2 through
step 7 .
8. Click OK on the Device_Name - Layer 2 ACL Configuration dialog box.
The Deploy to Products - Layer 2 ACL dialog box displays. To save the configuration, refer to
“Saving a security configuration deployment” on page 821
Assigning a Layer 2 ACL configuration to an interface (Fabric OS)
To assign Layer 2 ACL configuration to a interface, complete the following steps.
1. Select Configure > Security > Layer 2 ACL > Port.
The Port Selection - Layer 2 ACL dialog box displays.
2. Select a port or Link Aggregation Group (LAG) in the Available Ports list and click the right arrow
button.
LAGs display in the Available Ports list using the following convention: Po LAG_Number.
3. Click OK.
The Device_Name - Port_Number/LAG LAG_Number- Layer 2 ACL Configuration dialog box
displays.
FIGURE 269 Device_Name - Port_Number - Layer 2 ACL Configuration dialog box