Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 167)

100 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Configuring event-based collection
4
d. Select the Enable event triggered polling check box to enable adaptive discovery on the
predefined SNMP traps.
NOTE
This settings cannot be disabled for DCB switches.
NOTE
Network OS devices must be running version 4.0 or later to enable this setting.
NOTE
For Network OS devices, adaptive discovery is also performed for Syslog events.
The lazy polling function sends login and log messages to the Master Log and the switch
console. If you are receiving too many messages due to lazy polling, clear the check box to
disable off lazy polling.
You cannot change the lazy polling interval for IronWare OS or Network OS devices. The
lazy polling interval is based on the size of your network. For IronWare OS devices, default
values are as follows:
• Small: 2 minutes
• Medium: 15 minutes
• Large: 30 minutes
For Network OS devices, default values are as follows:
• Small: 15 minutes
• Medium: 30 minutes
• Large: 60 minutes
e. Click Apply to save your work.
4. Click Close to close the Discover Setup - IP dialog box.
5. Click Yes on the confirmation message.