Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 812)

756 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Layer 2 access control list management
22
8. In the Ethernet Type list, select one of the following options to specify the Ethernet type being
transferred in the Ethernet frame:
• ARP — Address Resolution Protocol
• IPV4-L5 — Internet Protocol, version 4-L5
• IPV6 — Internet Protocol, version 6
• Any — Any of the protocols
9. (Deny actions only) Select the Log Enable check box to generate a log for this configuration.
10. Click the right arrow button.
The new ACL rule displays in the ACL Entries list.
11. To create additional rules for the same ACL, repeat step 4 through step 10 .
12. Click OK on the Add - Layer 2 ACL Configuration dialog box.
The new ACL rule displays in the ACLs list. To create additional ACL, repeat step 2 through
step 12 .
13. Click OK on the Device_Name - Layer 2 ACL Configuration dialog box.
The Deploy to Products - Layer 2 ACL dialog box displays. To save the configuration, refer to
“Saving a security configuration deployment” on page 821.
Editing a Layer 2 ACL configuration (IronWare)
To edit a Layer 2 ACL configuration, complete the following steps.
1. Select the device and select Configure > Security > Layer 2 ACL > Product.
The Device_Name - Layer 2 ACL Configuration dialog box displays.
2. Select the ACL configuration you want to edit and click Edit.
The ACL_Number - Edit Layer 2 ACL Configuration dialog box displays.
3. Change the description of the ACL in the Description field.
4. To edit an existing ACL rule, complete the following steps.
a. Select the ACL rule you want to edit in the ACL Entries list and click the left arrow button.
b. Complete step 4 through step 10 in “Creating a Layer 2 ACL configuration (IronWare)” on
page 754.
The updated ACL rule displays in the ACL Entries list. To update additional rules for the
same ACL, repeat
step 4 .
5. To add a new ACL rule, complete step 4 through step 10 in “Creating a Layer 2 ACL
configuration (IronWare)” on page 754.
The new ACL rule displays in the ACL Entries list. To create additional ACL rules, repeat step 4
through step 10 .
6. To delete an ACL rule, select the rule in the ACL Entries list and click the left arrow button.
7. Click OK on the ACL_Number - Edit Layer 2 ACL Configuration dialog box.