Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 153)

86 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
IP SNMP credentials
4
Editing SNMPv1 and SNMPv2c credentials
To edit a SNMPv1 or SNMPv2c read-write community string, complete the following steps.
1. Select Discover > IP Products.
The Discover Setup - IP dialog box displays.
2. Click the Global Settings tab.
3. Click the SNMP tab.
4. Select the community string you want to edit in the Selected Read-Write Community Strings list
and click the left arrow button.
The selected credentials display in the Add/Edit Read-Write Community Strings area.
5. Enter a unique label to identify the community string in the Display Label field the Add/Edit
Read-Write Community Strings area.
This label can be from 1 through 16 characters long, case sensitive, and allows all printable
ASCII characters.
6. Enter the unique community string in the Community Strings field.
The community string can be from 1 through 16 characters long, case sensitive, and allows all
printable ASCII characters. The string displays as asterisks.
7. Click the right arrow button to add the read-write community string to the Selected Read-Write
Community Strings list.
NOTE
If the devices use multiple community strings, use the Up or Down buttons to place the most
commonly used community string at the top of the Selected Read-Write Community Strings list
to make discovery run more efficiently.
NOTE
If the Selected Read-Write Community Strings list does not contain any community strings, the
Management application uses the "public" and "private" community strings.
8. Click Apply to save your work.
9. Click Close to close the Discover Setup - IP dialog box.
10. Click Yes on the confirmation message.
Editing SNMPv3 credentials
To edit SNMPv3 read-write credentials, complete the following steps.
1. Select Discover > IP Products.
The Discover Setup - IP dialog box displays.
2. Click the Global Settings tab.
3. Click the SNMP tab.