Monitoring configurations, Creating a monitoring configuration, Creating a monitoring configuration 5 – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 1325: Monitoring configurations 5, Creating a, Monitoring configuration
Brocade Network Advisor SAN + IP User Manual
1275
53-1002949-01
Monitoring configurations
34
Monitoring configurations
You can create, modify, duplicate, and delete a monitoring configuration from the CLI Configuration
dialog box. Monitoring configurations allow you to create device reports by entering a set of show
CLI commands. To view a list of existing configurations, refer to
page 1258. For information about the example templates, refer to
Creating a monitoring configuration
To create a new monitoring configuration, complete the following steps.
1. Select Configure > CLI Configuration.
The CLI Configuration dialog box displays.
2. Click Add.
The CLI Template dialog box displays.
FIGURE 549
CLI Template dialog box - Definition tab
3. Click the Definition tab and complete the following steps.
a. Enter a name and description for the new configuration.
NOTE
Do not use special characters in the name.
b. Select Monitoring to create product reports using show commands.
c. To change CLI credentials, click Change Template Credentials and refer to