Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 594)

532 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Configuration repository management
14
• Fabric Name — The world wide name of the fabric selected for backup configuration.
• Status — The status of the fabric selected for backup configuration; for example,
unknown or marginal.
• # of Switches — The number of switches that are configured on the fabric selected for
backup configuration.
If any switches do not have the EGM license, a messages displays. Click OK to enable
backup on the switches with the EGM license.
5. Click OK.
Click OK on the confirmation message.
Restoring a configuration from the repository
If you delete a fabric or switch from discovery, the configuration remains in the repository until you
delete it manually. Stored configurations are linked to the switch WWN; therefore, if the IP address
or switch name is changed and then rediscovered, the Switch Configuration Repository dialog box
displays the new switch name and IP address for the old configuration.
NOTE
This feature requires a Trial or Licensed version.
1. Select Configure > Configuration > Configuration Repository.
The Switch Configuration Repository dialog box displays.
FIGURE 199 Switch Configuration Repository
The Saved Switch Configurations table displays the following information.
• Keep check box — Select to keep the associated configuration past the defined age limit.
The configuration will be kept until it is manually deleted, or until the Keep check box is
cleared to enable the age limit again