Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 189)

122 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Individual IP device discovery
4
2. Click Add.
The Add product dialog box displays.
FIGURE 40 Add product dialog box
3. Choose one of the following options:
• Enter the IP address (IPv4 or IPv6) of the IP device in the Network Address field.
• Enter the host name or DNS name (up to 64 characters) of the IP device in the Network
Address field.
NOTE
The Management application does not validate the Network address until you save your work.
4. Select one of the following options:
• Try only configured Discovery SNMP settings — Select to use the SNMP settings configured
in the Global Settings tab to contact the device.
• Also try these settings — Select to use specific SNMP settings to contact the device. If you
do not enter SNMP settings or if the settings do not authenticate on the device, the
application uses the SNMP settings configured in the Global Settings tab to contact the
device.
NOTE
You can configure both SNMPv3 and SNMPv1/SNMPv2c credentials at the same time;
however, discovery tries the SNMPv3 credentials before trying the SNMPv1 and SNMPv2c
credentials.
5. Configure the SNMPv3 read-write credentials by completing the following steps.
NOTE
These credentials are not applicable for DCB devices.
a. Click the SNMPv3 Read/Write tab.