Show system version – Allied Telesis AT-S63 User Manual
Page 101
AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations
101
SHOW SYSTEM VERSION
Syntax
show system version module=
id_number
|all
Parameters
module
Specifies the ID number of a switch in an AT-9400Ts Stack.
You can specify more than one ID number at a time. To specify
all of the switches in a stack, use the ALL option.
None.
Description
This command is used to display the version numbers of the AT-S63
Management Software on the master and member switches in an
AT-9400Ts Stacks. To display this information on stand-alone switches,
refer to “SHOW SWITCH MODULE” on page 96 or “SHOW SYSTEM” on
page 99.
Examples
This command displays the version number of the AT-S63 Management
Software on the master switch:
show system version module=1
This command displays the version numbers of the AT-S63 Management
Software on the master switch and member switch 3:
show system version module=1,3
This command displays the version numbers of the management software
on all of the switches in a stack:
show system version module=all