Allied Telesis AT-S63 - Manual (Page 187)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 187
SHOW SWITCH MODULE COUNTER
Syntax
show switch module= id_number counter
Parameters
module Specifies the stack ID number of a switch. For a stand-alone
switch, this number is 1. You can specify only one ID number at
a time. To determine the stack ID number of a switch, refer to
“SHOW STACK” on page 106.
Description
This command is used to display the operating statistics for stand-alone
switches and for master and member switches in an AT-9400Ts Stack.
The information includes the number of packets received and transmitted,
and the number of CRC errors. An example of the display is shown in
Figure 37.
Figure 37. SHOW SWITCH MODULE COUNTER Command
The command provides the following information:
Bytes Rx
Number of bytes received by the switch.
Bytes Tx
Number of bytes transmitted by the switch.
Frames Rx
Number of frames received by the switch.
Frames Tx
Number of frames transmitted by the switch.
Port: All
Bytes Rx ......... 983409801 Bytes Tx ......... 965734443
Frames Rx ........ 815423 Frames Tx ........ 691396
Bcast Frames Rx... 107774 Bcast Frames Tx .. 1853
Mcast Frames Rx .. 11429 Mcast Frames Tx .. 0
Frames 64 ........ 110509 Frames 65-127 .... 15192
Frames 128-255 ... 1928 Frames 256-511 ... 442
Frames 512-1023 .. 157796 Frames 1024-1518.. 1221024
CRC Error ........ 0 Jabber ........... 0
No. of Rx Errors . 0 No. of Tx Errors . 0
UnderSize Frames . 0 OverSize Frames .. 0
Fragments ........ 0 Collision ........ 0
Frames 1519-1522 . 0 Dropped Frames ... 0